Package Includes:
- (1) Planet Audio TR4000.1D Torque Series 4000w Mono Amplifier Class D 1-Ohm Car Amp
- (1) Rockville RWK4CU 4 AWG Gauge 100% Copper Complete Amp Installation Wire Kit OFC
Description:
Torque MODEL 4000W High Output Monoblock Class D Amplifier
Features:
- 1 Ohm Stable: The lowest impedance accepted by this amplifier is 1 ohm. Amplifiers that are 1 ohm stable produce the most power possible from the amp. An amplifier capable of delivering power at a 1 ohm load is usually reserved for serious subwoofers that can handle the power. Please note this particular amp needs a healthy electrical system including a low gauge wire capable of delivering the necessary current.
- Class D Amps: Class D is a high speed switching amplifier technology that is more efficient, generates less heat and draws less power than traditional Class A/B amps. We use Class D in our Monoblock amplifiers to give you massive amounts of power in a relatively small footprint for clean, powerful, bass.
- Phase Control: The phase control feature allows you to adjust the speakers phase to ensure all audio signals are playing together rather than against each other. When bass notes are noticeably absent, a quick and easy adjustment to the phase control could provide the perfect remedy.
- Protection: If the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself.
- Strapping Capability: Strapping capability means that two amplifiers can be linked together to create double the power at an impedance of 2 ohms. A benefit of strapping is less electrical current is required than if you ran [2] individual amps at 1 ohm and you only need 1 pair of preamp outputs and [1] RCA cable to connect.
- Subsonic Filter: A subsonic filter is designed for use on subwoofers. Since not all subwoofers can reproduce the same low frequencies, the subsonic filter can be set for optimum bass response in order to keep the driver playing efficiently.
- Subwoofer Level Control: The ability to boost or attenuate the sub level when an amp and subwoofer are connected to the subwoofer pre-amp output.
- Switchable Input Sensitivity: Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed.
- Variable Bass Boost: Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.
- Variable Gain Control: Variable Gain Control lets you balance the amps output with the speakers or subs the amp is driving. To much gain will lead to distortion and to little will lead to clipping.
- Variable Low Pass Filter: Variable low-pass filter gives you control over the frequencies that pass through to the subwoofer.
Specifications:
- MODEL 4000W High Output MONOBLOCK Amplifier
- Up to 3000 W X 1 RMS @ 1 ohm
- Up to 1500 W X 1 RMS @ 2 ohm
- Up to 750 W X 1 RMS @ 4 ohm
- Up to 6000 W X 1 RMS Strapped Bridged Power @ 2 ohm
- Monoblock Class D, MOSFET Power Supply
- Low Level Inputs, RCA Pre-amp Outputs
- Variable Low Pass Crossover, Variable Bass Boost and Variable Subsonic Filter and Switchable Phase Control
- Include Remote Subwoofer Control
- Blue Illuminated Planet Audio Logo
- Dimensions: 15.3" L x 9.75" W x 2.13" H
- Warning: California Prop 65 Warning
All About Your RWK CU Series:
Description:
We challenge anyone to put this wire to a resistance test against any other wire on the market with the same gauge. If our cable does not meet or exceed any other cable, even if it costs 3 times more, we will be happy to call tag the item and refund you in full. Why are we so confident ? This cable is 100% copper. You cant have a cable with more than 100 % copper. So the only way a cable would out-perform this one is if it were being advertised as a 4 AWG but they are giving you more wire than advertised. No brands selling 100 % copper cables actually do this.
We guarantee that this kit will compete with the most expensive amp kits on the market from Kicker, JL Audio, or any other top brands.
Maximum Power!
Looking for a wire kit that has 100% true specifications! A wire kit that uses 100% copper 4-gauge cable! Then look no further than the Rockville True-Spec RWK4-CU 4 Gauge Amplifier Wiring Installation Kit. This package includes everything you'll need to get your amplifier system powered-up correctly and at peak efficiency. All items included in this kit are top of the line.
The power and ground cables aptly named "Mega Power Cable" is a no compromise power cable. Rockville's engineering team over-built and designed the cables using thousands of strands of only true 100% oxygen-free, silver-tinned copper strands. The use of a proprietary special twisting process reduces "surface skin impedance loss" so that Mega Power cables have zero signal and power loss, delivering full power from your battery system to your amplifier even at lengths of 20 feet! The increased current flow and higher amperage carrying capacity will increase your amplifiers efficiency and keep your amplifier running cooler. The SuperFlex outer insulating jacket jacket makes installation and cable routing simple and easy. The 100% copper stranded wire is extremely tolerant of the hostile conditions found under the hood in vehicles and compensates for vibration, heat expansion and flexibility. This flexible and well-shielded wire is crucial for getting through all of the nooks and passageways within the confines of a vehicle interior.
Some manufactures use all aluminum or mix a little copper with aluminum to give their cables the appearance of a "heavy-duty" cable. But not Rockville, our True-Spec 100% oxygen free, silver tinned copper eliminates corrosion, increases current transfer x 10, and won't discolor over time.
The superior quality and materials of the Rockville 100% True-Spec amplifier installation kit is realized in the included accessories and cable workmanship. Included is a precision CNC cut full size ANL fuse housing, machined from solid brass and then 14K gold plated for superior signal transfer and complete with a matching gold plated 120-amp ANL fuse. The power cable is wrapped in 6 feet of durable nylon braided tubing to protect it from heat and chafing in the engine compartment. All installation accessories such as the ring terminals and spade connectors are nickel plated for superior signal transfer and durability.
CRYSTAL SQ AUDIO PLANAR SPEAKER CABLE
The speaker cable included in the Rockville True-Spec is also manufactured from 100% copper and woven in to a flat planner design and coated in our Super-Flex insulation so that it fits under and around your vehicles trim and carpet smoothly and without bulking up. With crystal clear sound quality these speaker cables deliver true audio fidelity from your car audio amplifier to your speakers. The 14-gauge speaker cable included in the 4-gauge kit can handle over 2000 watts of power without heating up or degrading signal quality.
CRYSTAL SQ RCA AUDIO INTERCONNECT CABLE
Designed and engineered to be the best sounding, best performing and best looking RCA cables available today. Each channel in the RCA cable is triple shielded first with dielectric internal insulators and then with a 98% coverage woven shield. All cables are manufactured of 100% oxygen free copper and feature twisted pair technology for superior noise rejection and pure sonic signal flow. The RCA plugs are shielded metal and feature a spiral cut outer ground ring with center split pin for precise and tight audio connections. The result of all this technology is noise free-noise rejection signal transfer for optimum sound quality. You will hear the difference these RCA signal transfer cables will make.
Amplifier Kit Key Features:
- Rockville RWK4CU 4 Gauge 2 Channel Complete Car Amplifier Installation Kit 100% Pure Copper RCA Cables
- 4 Gauge Power Amplifier Installation Kit
- Designed specifically for car audio systems over 1000 watts RMS to 2000 Watts
- Made from silver-tinned 100% virgin copper for a pure uninterrupted transfer of power and signal
- The solid brass gold plated Mini ANL Fuse Holder offers ideal protection for high powered systems
- Strand Count: 1862
- BC-5W2 Compliant
Kit includes:
- 17 ft. Frosted Blue 4 gauge power wire with seamless crimp ring terminal
- 3 ft. Frosted Gray 4 gauge ground wire
- 17 ft. Blue 18 gauge remote lead wire
- 25 ft. Frosted Clear/Blue 14 gauge flat speaker wire
- 17 ft. Triple shielded twisted pair RCA cables
- One Mini ANL Fuse Holder with 120 amp ANL fuse
- One 1/2" black rubber firewall grommet
- One 4 gauge spade terminal
- Two black 12 gauge nickel-plated spade lugs
- Three blue 12 gauge nickel-plated spade lugs
- One black 4 gauge ring terminal
- Ten 6" black zip ties
