Description of SPV-65X-WRA:

The SPV-65X-WRA is a complete speaker system upgrade that is Alpine engineered for the 2007-2018 Jeep Wrangler JK

SOUND THAT’S OPTIMIZED FOR THE JK
These 6.5-inch speakers in the SPV-65X-WRA are tuned specifically for the JK’s in-cabin environment and fit into the factory speaker locations for an easy update that will impress your ears.

WEATHER RESISTANT
Driving with the top off is part of the fun of owning a Wrangler, but sometimes you get caught off-guard with the top down and inclement weather. The SPV-65X-WRA is weather resistant and rated IP55, so it’s protected from limited dust ingress and low-pressure water spray from any direction.

SPEAKERS BUILT FOR YOUR 2007-2018 JK
The SPV-65X-WRA comes with adapters that allow the speakers to be installed as a component set by mounting the tweeters into the tombstones of older JKs or onto the dash for newer JKs. For older JKs that have a sound bar, the adapters convert the speakers into a coaxial design so they can be installed into the sound bar.

Features:

• ALPINE SPV-65X-WRA Weather Resistant 6.5" Speakers for 2007-18 Jeep Wrangler JK
• 6.5-inch speakers which can be installed as a component or coaxial system, using the included adapters
• CTA-2031 Power Rating: 75W RMS, 225W Peak
• Nominal impedance 4 Ohm
• Frequency response 65-22kHz
• 1” Teteron dome tweeter
• Steel frame with factory speaker mounting tabs
• Weather resistant: IP55
• Includes vehicle specific speaker connectors

Video of R7EQ:

Includes:

• Equalizer
• Screws
• Bracket
• Owner manual
• Warranty card

Features:

• Rockville R7EQ 1/2 Din 7 Band Car Audio Equalizer EQ w/ Front, Rear + Sub Output
• Includes mounting brackets and screws for easy installation
• 7 adjustable bands of equalization (50Hz,125Hz,315Hz,750Hz,2.2KHz,6KHz and 12KHz)
• Each band is adjustable from -18dB to +18dB
• Adjustable subwoofer frequency from 40Hz to 250Hz
• Built in crossover
• Subwoofer level controls and subwoofer frequency cutoff controls (40-250 Hz)
• Built in 7 volt line driver
• Blue LED lights on each rotary knob
• Front, rear, and sub preamp outputs
• Aux input with gain knob to adjust aux volume
• Strong metal chassis with high quality rotary knobs for all controls
• Amazing quality with low distortion (Built with top quality components)
• Frequency response: 20Hz TO 20KHz +/- 1dB
• S/N Ratio: 101 dB
• Crossover Roll-Off: 12dB per octave
• Input impedance: 10K
• Input sensitivity: 200mv per channel >7V
• THD: 0.01%
• Input: 12V
• Output: 15V
• Power requirement: 11-16V DC
• Unit dimensions in inches: 7.04” x 4.72” 1.1”

Controls: (Click here for diagram)

1. Master volume
2. Sub volume
3. Sub frequency (40-250Hz)
4. Fader
5. Input selector switch
6. 50 Hz control (+ or = 18 dB)
7. 125 Hz control (+ or = 18 dB)
8. 315 Hz control (+ or = 18 dB)
9. 750 Hz control (+ or = 18 dB)
10. 2.2 KHz control (+ or = 18 dB)
11. 6 KHz control (+ or = 18 dB)
12. 12 KHz control (+ or = 18 dB)

Owner’s Manual