- (1) Pair Rockville RKL65MBW 6.5" 700w Marine Boat Speakers w/LED+Black/White Grilles
- (1) Rockville ATV220 2 Channel UTV/Motorcycle Bluetooth Amplifier IP65 Micro Amp
All About RKL65MBW:
How To Install Kick Panel Speaker Pods In A UTV:
Includes:
- Pair of 6.5" Marine LED Speakers
- 16.4 feet of Speaker Wire
- Stainless Steel Mounting Screws
- Black and White Grills Included
Features:
- Pair Rockville RKL65MBW 6.5" 2-Way 700 Watt Marine Boat Speakers with LED Lights
- CEA Compliant Power Ratings
- True Coax Design With the Tweeter Completely Separated From the Cone
- Larger Cone Surface Area Gives Better Mids and Lows
- Less Mass Attached to the Cone Allows for Higher SPL and Sensitivity
- True coaxial design allows for superior sound quality, better stereo separation, and clearer mids and highs
- Power Rating: 350 Watts Peak/85 Watts RMS Per Speaker
- Total Power: 700 Watts
- Beat sync LED's flash to the rhythm of the music
- You can select either red or blue color LED's on the wire harness
- No extra installation for the LED. It gets a power signal through your speaker wire
- The louder the music the more intense the LED's flash
- Black and White detachable Grills
- Fully Marinized Against Salt & Fresh Water Conditions
- UV treated cone makes this completely Waterproof and rustproof
- Anti-corrosion Stainless Steel Terminals
- Molded ABS plastic for amazing sound and protection from the elements while out on the water
- Polypropylene Formed Cone
- 10 Oz Y30 top of the line magnet supports high power handling
- Rubber Surround
- High quality ferrite magnet
- 1" inch Polymer Tweeter
- Oversized 1" CCAW Kapton Voice Coil
- Pre-installed Stainless-Steel mounting screws included
- Perfect for Marine, Car, ATV and UTV applications
- Impedance: 4-Ohm
- Frequency Response: 35Hz - 20KHz
- Sound Pressure Level: 90dB @ 1w/1m
- Total Diameter: 7.3"
- Cutout Diameter: 5.6"
- Total Height: 3.86"
- Mounting Depth: 2.56"
All About Your ATV220:
How To Set Up Your ATV220:
How To Set Up Your ATV220 To a Head Unit:
Wires, Inputs, Outputs explained on your ATV220:
Description:
The Rockville ATV220 is a 2 channel amplifier for your ATV. It will deliver 180 x 2 @ 2 ohms RMS. We dyno-test the amp to make sure you get the power we promise.
This amp is IP65 which means even if you submerged it in water for a few seconds it would still function fine. This means you do not need to worry about your amp breaking when you spray down your vehicle.
The built in Bluetooth is great because you do not even need a head unit or controller. You can just install this amp and wire it to your speakers and Bluetooth your phone to the amp.
This amp is super compact making it easy to install in tight spaces.
If you want the most waterproof and high performing ATV amplifier on the market then this is a great option for you.
Features:
- Rockville ATV220 2 Channel UTV/Motorcycle Bluetooth Amplifier IP65 Waterproof Micro Amp
- Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc)
- 2 Ohms: 400 Watts (2 x 200 Watts)
- 4 Ohms: 250 Watts (2 x 125 Watts)
- Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc):
- Peak 2 Ohms: 1600 Watts (800 x 2 Watts)
- Bridged Power Rating: 4 Ohms Bridged: 400 Watts
- Built in Bluetooth Wireless with Auto Pairing (You can run this amp without any receiver)
- IP65 waterproof rating
- All inputs and wire wiring is sealed and covered
- Conformal coated circuit board
- Anti rust materials
- This is one of the only amps on the market that is IP65. That means even if you submerged it for a couple of seconds it would work fine
- Efficiency at Full Power 4 Ohm (1kHz) 84.8%
- Efficiency at Full Power 2 Ohm (1kHz) 77.8%
- Micro Size amplifier can easily fit in tight spaces
- Digital Class D Audio Topology
- Distortion(THD): =0.5%
- Full Range/Low Pass/High Pass Configurable
- High Input (Speaker level Input)
- Low Pass Crossover: 32Hz-320Hz
- High Pass Crossover: 32Hz-320Hz
- Waterproof sheath RCA Input
- Frequency Response: 20Hz-22KHz
- Signal to Noise Ratio: (1 Watt into 4 Ohms) =80dB
- Input Sensitivity: 0.2V-6V
- Speaker level Input Sensitivity: 0.5V-15.5V
- Stereo Separation: =50dB
- Fuse Rating: 35A
- Dimensions (Inches): 8.66" L x 3.74" W x 1.73" H
- High-Speed MOSFET Power supply
- Status Mode LED Indicator
- Waterproof Grade: IP65
- UPC:
- 613817086480
