Package Includes:

• (1) Pair of Rockville MS40B Black 4" 200 Watt Marine Boat Speakers Compact and Powerful
• (1) Hifonics TPS-A500.2 500w 2-Channel Marine Amplifier For Polaris RZR/ATV/UTV/Cart
• (1) Hifonics TPS-BT1 Bluetooth Marine Pre-Amp Controller 4 Polaris RZR/ATV/UTV/Cart
• (1) Pair of Rockville MAC40S 4" Chrome Swivel Aluminum Tower Handlebar Speaker Pods ATV/UTV

---

Video of MS40:

• 2 Speakers
• Installation Hardware: (8 Stainless Steel Screws + 8 Stainless Steel Speed Clips)
• Mounting Template
• Owner's Manual
• Warranty Card

Features of MS40B:

• Pair Rockville MS40B 4" 200 Watt Waterproof Marine Boat Speakers
• Peak Power: 200 Watts per pair / 100 Watts each
• RMS Power: 50 Watts per pair / 25 Watts each
• Color: Black
• Injection Molded Polypropylene Cone
• Aluminum voice coil with ASV winding
• Cloth surrounds
• Impedance: 4 Ohm
• Frequency Response: 122Hz – 20 Khz
• Sensitivity: 85dB @1w/1m
• High quality magnet: 3.5 Oz Y30 Ferrite magnet
• 1” inch ASV voice coil
• IP56 waterproof rating
• Fully Marinized Against Salt & Fresh Water Conditions
• Completely Waterproof and rustproof at level IP56
• Anti-UV molded ABS plastic basket & grill
• Pre-installed mounting screws included
• Perfect for marine, outdoor, and car use
• 1” inch Tweeter: (Mylar Diaphragm with NdFeB magnet)
• Injection Molded Polypropylene Dust Cap
• SPL: 85dB ± 2dB (at 1M / 1W)
• Resonant Frequency (F0) 122Hz + or – 20% at 1V
• 3MM plate and 3 MM T-yoke
• Total Diameter: 5.12”
• Cutout Diameter in Inches for Mounting: 3.66”
• Total Height: 2.36”
• Mounting Depth in inches:1.57’’
• Shipping weight: 1.76 Lbs
• Shipping Dimensions:6” x 6” x 5.7”

T/S Parameters:

• Magnet details: F60*F24*8 Y30
• Fs:154.7 Hz
• Re:3.2 ohms
• Qes:2.57
• Qts:1.611
• Qms:4.315
• Vas:0.847L
• Cms:210.222UM/N
• Bl:2.468T
• MMS:5.029g
• XMAX:1.5 mm
• SD:54 cm2

 

---

Description of TPS-A500.2:

Hifonics THOR compact Two Channel, 500 watt Powersports amplifier with on-board equalization and simple installation with quick release connectors.

Features:

• Hifonics TPS-A500.2 500w 2-Channel Marine Amplifier For Polaris RZR/ATV/UTV/Cart 
• Marine Grade Protection: YES - Amplifiers are ABYC & ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.
  
• Pre-Amp Circuitry: Low Noise Pre-Amplifier Stage - Special preamplifier reduces incoming noise from source units dramatically improving sound quality
  
• Inputs: 1 Pair, RCA Nickel-Plated - High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant
  
• Operation Mode: Two channel operation - Flexible installation allows this amplifier to run in two channel or bridged mono mode.
  
• Crossover / Signal Shaping: Switched FULL / LPF / HPF - Complete control of amplifier signal, essential when using two or more amplifiers
  
• Class / Topology: Full Range Class D - Highly efficient circuit topology which helps the amplifier develop a lot of power in a very small heatsink.
  
• Output Devices Technology: PWM MOSFET Power Supply - Stable power through the PC board with minimal heat generation
  
• Heat Sink: Aluminum - Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration
  
• Power Supply: Simpatico Coil Design - The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices
  
• Output Connections: Quick Dissconect Wires, RCA Connections - Quickly remove amplifer when you are putting machine up for the winter of as a security precaution
  
• Connections Type: Gold-plated connections - Gold-plated power, ground, speaker and RCA corrosion resistant connections
  
• Diagnostics: Three-stage protection circuits - Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel
  
• Marinized / Waterproof: YES - Water resistant for durability in any environment
  

Specifications:

• Class: Full Range Class D
  
• Variable Voltage: 0.2V~9V
  
• Signal to Noise Ratio: >90dB
  
• Frequency Response: 20Hz-20kHz
  
• Crossover Type: Electronic 12dB Per Octave
  
• Crossover Frequency Range CH1 & CH2: Switch Low Pass 300 Hz
  
• Bass Boost: 0-12dB@45Hz
  
• Subsonic Filter: 60Hz
  
• Power @ 2-Ohms: 2 x 250W
  
• Power @ 4-Ohms: 2 x 125W
  
• Total Channels: 2
  
• Audio Inputs: RCA
  
• Power Terminal 12v/GND: Molex 10 ga
  
• Speaker Terminal Wire Gauge: Molex Plug Connector
  
• Fusing: 1 x 30 Amps
  
• Certifications: Marine & Powersports
  
• Dimensions: 3.70 X 5.51 X 1.77 inches (9.4 X 14.0 X 4.5 cm)
  
• Weight: 2.12 lbs (0.96 kg)

---

Description of TPS-BT1:

For installations where a full size radio/source until will not fit, Hifonics has designed the ridiculously small TPS-BT1 Bluetooth, pre-amp controller. That model comes from THOR Power Sports Bluetooth 1. It might be your favorite controller you have ever used. The amount of control and connectivity you will have at your fingertips is shocking.

All the music, from your Bluetooth enabled device, directly into your system via this small controller. The TPS-BT1 is fully IPX67 protected against the elements so it is perfect for installation right in the dash of your Side-X-Side or off road application.  

For custom car builders, looking to keep an original clean look, This Bluetooth controller is a great option to changing out the original dash radio in a classic.    

Features:

• Hifonics TPS-BT1 Bluetooth Marine Pre-Amp Controller 4 Polaris RZR/ATV/UTV/Cart 
• Pre-amp controller
  
• Volume and track selection are controlled by the multi-functional joystick
  
• 2 volts output
  
• Waterproof Bluetooth controller designed to fit into a small hole
  
• iPhone, Android & Bluetooth Device Ready

---

Video of MAC40:

Includes:

• (2) 4” Aluminum Speaker Pods
• (2) Clamps
• (2) 3 mm Rubber Inserts
• (2) Brackets
• All mounting hardware

Rockville is proud to introduce our all new line of 4” aluminum Tower Handlebar speaker pods. The MAC40S comes in pairs and includes rugged aluminum clamps for easy installation to any bar measuring from 3/4" to 1.5" diameter. Two precision molded high impact rubber inserts guarantee a nice tight fit. Our clamp inserts are precision-fitted to sit perfectly inside the metal clamps.

These awesome pods are built of super strong aircraft grade 6061 aluminum. The MAC40S features a Polished finish which offers unparalleled resistance to chipping, scratching, and fading. These pods are fully marinized and 100% waterproof meaning they were designed to withstand even the harshest weather conditions. Aluminum cans will last forever!

The sound quality of our pods is phenomenal! They feature the right amount of air space which translates to perfect sound quality for use with our Rockville or Polk Audio or Kicker 4” marine speakers. Our high efficiency design means more output! More audio output gets you louder, cleaner sound with less distortion.

Features:

• Pair Rockville MAC40S 4" Chrome Swivel Aluminum Tower Handlebar Speaker Pods ATV/UTV
• Beautiful Polished Chrome finish
• Pods Made from high quality 6061 aircraft grade aluminum
• 100% waterproof and fully marinized against the elements
• High efficiency design features the perfect airspace for Select Rockville Kicker and Polk Audio 4” speakers
• Rugged 360-degree swivel mounting clamps made of 6061 aluminum
• Clamps feature Stainless steel quick release hand knobs for adjustment and security
• Fits round or square bars from 3/4” diameter to 1.5” diameter
• Includes Rubber inserts to protect your bar and ensure a snug fit
• 360-degree axis rotation in either direction, allowing the speaker cans to be aimed in the most desirable location to deliver maximum sound quality.
• Can be mounted on Flat surfaces
• Color: Chrome
• Mounting Depth - 2.75"
• Total Depth - 4.86"
• Cutout - 3.8"
• Diameter - 5.3".
• Mounting diameter - 4.67" (Narrow diameter - 4.26")
• Height of mount - Varies
• Total height of unit - Varies with mount configuration