Package Includes:

• (1) Kicker 45KM102 10" 350w Peak/175w RMS Marine Boat Subwoofer SVC 2-ohm Sub KM10
• (1) Hifonics TPS-A500.1 500w Mono Marine Sub Amplifier For Polaris RZR/ATV/UTV/Cart

---

Authorized Kicker Dealer! 

What's In The Box:

• (1) 10" Woofer
• (1) Back Gasket
• (8) Mounting Screws
• (8) Mounting Screw Clips
• (1) Owner’s Manual

Description of 45KM102:

The KICKER® KM 10-inch Marine Subwoofer is made to work perfectly in a sealed or ported enclosure. Packed with features and made for marine, KICKER gives you the deep, loud bass your boat needs with KM subs.

Features:

• KICKER 45KM102 10" 350w Peak/175w RMS Marine Subwoofer SVC 2-Ohm
• RMS Power Handling: 175 Watts
• Peak Power Handling: 350 Watts
• Two-Ohm Voice Coil
• Injection-Molded Polypropylene Cone
• Co-molded Santoprene® Surround
• UniPlate™ Back Plate And Pole Piece
• Thick Tinsel Leads
• Large Ceramic Magnet
• Rear Gasket Included
• Polymer Basket Resists Corrosion
• Protective Terminal Cap
• Stainless Mounting Hardware Included
• Meets or Exceeds ASTM Standards for UV and Salt/Fog Exposure
• Frequency Response: 30 Hz - 500 Hz
• Impedance: 2 Ohms
• Mounting Depth: 5" inches
• Hole Diameter: 9 3/16"
• Sealed Enclosure Volume Min-Max: 1-2.4 cubic feet
   

---

Description of TPS-A500.1:

Hifonics THOR compact 500 watt mono Powersports amplifier to for a subwoofer with on-board equalization and simple instalation with quick release connectors.

Features:

• Hifonics TPS-A500.1 500w Mono Marine Sub Amplifier For Polaris RZR/ATV/UTV/Cart 
• Marine Grade Protection: YES - Amplifiers are ABYC & ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.
  
• Pre-Amp Circuitry: Low Noise Pre-Amplifier Stage - Special preamplifier reduces incoming noise from source units dramatically improving sound quality
  
• Inputs: 1 Pair, RCA Nickel-Plated - High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant
  
• Operation Mode: Mono operation - Designed to power 1 subwoofer or subwoofer system
  
• Crossover / Signal Shaping: LPF - Complete control of amplifier signal, essential when using two or more amplifiers
  
• Class / Topology: Full Range Class D - Highly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.
  
• Output Devices Technology: PWM MOSFET Power Supply - Stable power through the PC board with minimal heat generation
  
• Heat Sink: Aluminum - Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration
  
• Power Supply: Simpatico Coil Design - The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices
• Output Connections: Quick Dissconect Wires, RCA Connections - Quickly remove amplifer when you are putting machine up for the winter of as a security precaution
  
• Connections Type: Gold-plated connections - Gold-plated power, ground, speaker and RCA corrosion resistant connections
  
• Diagnostics: Three-stage protection circuits - Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel
  
• Marinized / Waterproof: YES - Water resistant for durability in any environment
  

Specifications:

• Class: Full Range Class D
  
• Variable Voltage: 0.2V~9V
  
• Signal to Noise Ratio: >100dB
  
• Frequency Response: 10Hz-300Hz
  
• Crossover Type: Electronic 12dB Per Octave
  
• Crossover Frequency Range CH1 & CH2: Switch Low Pass 300 Hz
  
• Bass Boost: 0-12dB@45Hz
  
• Subsonic Filter: 60Hz
  
• Power @ 2-Ohms: 1 x 500W
  
• Power @ 4-Ohms: 1 x 250W
  
• Total Channels: Mono
  
• Audio Inputs: RCA
  
• Power Terminal 12v/GND: Molex 10 ga
  
• Speaker Terminal Wire Gauge: Molex Plug Connector
  
• Fusing: 1 x 30 Amps
  
• Certifications: Marine & Powersports
  
• Dimensions: 3.70 X 5.51 X 1.77 inches  (9.4 X 14.0 X 4.5 cm)
  
• Weight: 2.09 lbs (0.95 kg)