Package Includes:

• (1) Kicker 12" Car Subwoofer
• (1) Rockville Single 12” MDF Vented Square Solo Baric L7/L5/L3 Enclosure Box
• (1) Rockford Fosgate R750-1D 750 Watt Rms Class D Mono Amplifier Car Amp
• (1) Rockville RWK41 4 Gauge Complete Car Amp Wiring Installation Wire Kit with RCA's
• 10 Drywall Wood Screws (Wood screws are the type of screws; the screws are actually made of metal)
• 12 Feet of 14 AWG Blue Speaker Wire
• 2 Spade Terminals

---

Authorized Kicker Dealer!

Description for Kicker Sub:

Square Matters
The Solo-Baric revolves around KICKER's most advanced cone design, the injection-molded SoloKon™. The 360-degree, constant-contact back bracing adheres directly to every contour of the square cone, adding targeted strength, reliable performance and accurate response for the super-clean bass you’ve been looking for.

Features:

• Kicker L7S124 12" 1500 Watt Solobaric L7S Car Subwoofer Solo-Baric 44L7S12-4
  
• Dual Four-Ohm Voice Coils
  
• Injection-Molded Polypropylene Cone
  
• Patented Corner Ribs Minimize Distortion
  
• SoloKon™ 360-Degree Back Bracing
  
• Ribbed Santoprene Surround With Blue Surround Stitching
  
• UniPlate™ Back Plate And Pole Piece, Plus Perimeter Venting For Excellent Thermal Management
  
• Thick Tinsel Leads
  
• Large Ceramic Magnet
  
• Cast Aluminum Basket
  
• Satin-Nickel Plated, Spring-Loaded Speaker Terminals
  
• The Solo-Baric L7S 12-Inch Subwoofer works best with a sealed or ported enclosure and 750 watts of recommended power. See below for more details.
  

Specifications:

• Size: 12" (30.5 cm)
  
• Impedance: 4 Ohms DVC
  
• Max Rec Amplifier Power: 1500 Watts Peak / 750 Watts RMS
  
• Sensitivity: 88.6 dB 1w/1m
  
• Frequency Response: 20Hz - 100Hz
  
• Mounting Depth: 6-11/16" (16.9 cm)
  
• Mounting Cutout, Square: 11-1/16" (28.1 cm)
  
• Min Rec Sealed Box Volume: 0.88 cu. ft. (24.9 liters)
  
• Max Rec Sealed Box Volume: 2.0 cu. ft. (56.6 liters)
  
• Min Rec Vented Box Volume: 1.75 cu. ft. (49.6 liters)
  
• Max Rec Vented Box Volume: 3.25 cu. ft. (92.1 liters)

---

Features of R750-1D:

• Variable crossover 12dB/octave slopes
• 4 Gauge power/ground terminals
• Cast aluminum heatsink
• Infrasonic filter
• RCA pass-thru
• Top mounted controls
• Tri-stage protection covers thermal, over-current and short circuits
• On-board PEQ (Punch Equalization) with 18 dB of boost at 45Hz
• CEA-2006 Compliant

Specifications:

 

• Number of Channels: 1
• RMS Power Handling:
• 400 Watts x 1 @ 4-Ohms
• 600 Watts x 1 @ 2-Ohms
• 750 Watts x 1 @ 1-Ohm
• Total Power (Sum of RMS Power): 750 Watts
• Low-Pass Crossover Controls: Variable 50Hz - 500Hz @ 12dB/Octave
• Tone Controls: 0dB to +12dB @ 45Hz
• Low Level Signal Input: 1 RCA Pair
• Signal Output: 1 RCA Pair
• Power Input Connector: Block
• Power Wire Gauge: 4 AWG
• Speaker Output Connector: Block
• Speaker Wire Gauge: 12 AWG
• Remote Controls: Variable 0dB to +12dB @ 45Hz
• Visual Indicators:
• Power
• Protect
• Circuit Topology Class: Class-D
• Dimensions (H x W x L): 2" x 6.7" x 9.1"

---

Description for Rockville Enclosure:

The RSVK12 single vented speaker box is made in the USA with Grade “A” ¾” MDF wood specifically for Kicker square subwoofer. This enclosure is made with precision cutting machinery by industry experts that have been making these enclosures in the USA for over 20 years. All Rockville enclosures come with a customized enhanced glue that is unmatched by any other manufacturer. That means that the carpet will stay in place and not rip or tear. The ¾” USA MDF is much stronger then any type of import wood.  This will keep your box performing at an optimal level by not flexing and distorting your woofers. Your woofers will thank you!  EVERY Rockville enclosure is not only glued at all joints but stapled as well. If that wasn’t enough we add a layer of silicon to every seam! This makes your Rockville enclosure rock even more!

MADE IN THE USA WITH PRIDE!

Features:

• Rockville RSVK12 Single 12" Vented Square Subwoofer Enclosure
• Proudly Made In The USA, Using Only The Finest Quality Materials - For The Best Level of Performance From Your Subs!
• Factory Matched To Work With 12" Kicker Solo-Baric L7 or L5 or L3, Hifonics square woofers, and other square woofers
• 3/4" USA Heavy Duty MDF Construction
• Machine precision cut mounting holes
• Top of the line Glue for extra durable adhesion
• High quality GOLD spring loaded terminals
• Designed, tested, and engineered to work with Kicker’s L7, L5, and L3 Square Woofers as well as many other square woofers on the market!

Enclosure Measurements:

• Type of Enclosure: Vented
• Enclosure Sub Size: Single 12" Square
• Dimensions in Inches: 16.0" L x 18.0" W x 13.25 H"
• Top and Bottom Depth: 16.0"
• Mounting Depth: up to 14.5" (enough depth for any sub on the market)
• Tuning Frequency: 38Hz
• Port Dimensions: 2" x 21" x 12"
• Gross Volume Per Sub (Measurement for the outer dimensions of the box): 1.50 Cubic Feet
• Net Volume Per Sub (Measurement for the outer dimensions of the box less the thickness of the wood and port): 1.22 Cubic Feet

---

Complete Single Subwoofer Enclosure Installation Kit!

Includes:

• 10 Drywall Wood Screws (Wood screws are the type of screws; the screws are actually made of metal)
• 12 Feet of 14 AWG Blue Speaker Wire
• 2 Spade Terminals

This accessory package includes everything you need to install one subwoofer into an enclosure, and wire to connect the enclosure to your amplifier.  This package is a top of the line accessory package which we put together and tested. 

The drywall wood screws were hand selected by our installation experts because they drill into the enclosure very cleanly, without chipping the enclosure.  The speaker wire is 14 gauge.  This is way better than using 16 gauge.  You can be 100 % sure that your enclosure will have a clean signal to the amplifier with this top of the line speaker wire.  These spade terminals have also been hand selected by our installation experts to make the internal wiring simple, secure, and to run the audio signal cleanly.

---

Video of RWK41:

Unboxing Video for RWK41:

Description:

The Rockville RWK41 4 AWG (American Wire Gauge) amp kit has the following differences over other amp kits on the market at this price point.

1. Our RCA cables are 100 % copper. These are top of the line RCA cables

2. Better Resistance: The only thing that really matters with wires is the resistance rating. This is a measurement of conductivity and how much signal is loss per foot of wire. Since Rockville wires are made with around 3 times as much copper as any other wire at this price point, these wires had a much better resistance rating which means they will transfer more power to your amps than the other brands.

3. We do not cheat you on the thickness of the wire. These are standard American wire gauge thickness. This is another reason our conductivity is better than anything else at this price point. Other brands in the market place write 4 gauge, but cheat you on the thickness. We are honest about the thickness.

4. The Rockville amplifier installation kits feature a new soft abrasion proof insulating jacket. This rugged PVC outer jacket allows for 100% improved flexibility over standard power cables making them extremely easy to route through your vehicles interior, and it maintains exceptional resistance to grease and oil. The PVC outer jacket can with-stand an extreme temperature range of -40 to 220 degrees F.

The RCA signal transfer cables included in this kit feature blue and silver twisted pair technology in a clear outer jacket insulation skin. Not only do the blue and silver wires look cool but they also provide superior signal transfer with maximum noise suppression. They are 100% copper to provide absolute lossless perfect signal transfer to your receiver. This technology reduces interference, so your audio signal flows clean and pure at all power levels.

This kit also includes a massive 60 Amp AGU Gold Plated Fuse, so you can be sure it will handle the all the DC power that your amp will need without even the slightest loss of current. The included 7 split loom tube provides protection for your power cable from the typically harsh environment found under the hood of your car.

Audiosavings product experts have tested this amp kit against many leading amp kits on the market and were were impressed not only by the great looks but by the quality of these Rockville installation kits as well. These kits had a lower resistance rating than the other brands we compared and tested them against. What this means is that Rockville manufactures their kits with more copper than other kits at this price point, ultimately providing your amplifiers with better and cleaner DC power, so they work cooler and more efficiently. You will hear the difference a Rockville installation kit will make!

Features:

• 1 – 17’ High Grade Twisted Pair of 100% Copper RCA Cable
• 17’ – 4 Gauge Translucent Blue SuperFlex Power Cables
• 17’ – 18 Gauge Blue Remote Cable
• 17’ – 16 Gauge Clear Speaker Wire
• 3’ – 4 Gauge Clear SuperFlex Ground Wire
• Gold Plated AGU Heat Resistant Fuse Holder
• 60 Amp AGU Gold Plated Fuse
• 7’ Split Tube Loom
• Accessories Included: Wire Ties, Ring Terminals, Butt Connectors, Spades, and Grommets