Authorized Kicker Dealer!

PX Amplifiers :
PX Amplifiers are specially designed to deliver tremendous power in a tiny, weatherproof footprint – without taxing your charging system.

Go Anywhere :
Whether it's in a car, motorcycle, or any vehicle with a small charging system - you want an amp tough enough to thrive no matter where the ride takes you. A weatherproof wiring harness, moisture-resistant circuit board and aluminum casing.

Full Control :
With auto turn-on options, built-in crossovers and flexible input styles, KICKER® amps give you the custom sound you need. Add the CXARC Remote Bass Controller to any mono PX amp for adjustable volume, right from the drivers seat.

Big Power. Mini Size :
With as much as 500 watts of power, the only thing small about these amps is their footprint. Made to fit nearly anywhere, these miniature power plants start at under five inches in total width. 

PXA300.4 Amplifier :

The PXA300.4 Four-Channel Amplifier is built to power every speaker in your ride.

Perfect for motorcycles, side-by-sides, ATV’s and more, this weatherproof amp delivers huge power, on or off the road. With a 24dB crossover and subsonic filter included, you can perfect your sound and ensure long speaker life. A wide range of input levels make this amp easy to hook up with a factory radio or aftermarket.

This PXA amplifier delivers as much as 75 watts per channel (4 channels driven), or 150 watts into two sets of bridged channels. See below for more details.

Features:

• Kickerf 42PXA300.4 300 Watt RMS Motorcycle/ATV/Marine 4 Channel Amplifier
• RMS Power in Watts :
• 50 watts RMS x 4 at 4 ohm ( 75 watts RMS x 4 at 2 ohm )
• 150 watts RMS x 2 at 4 ohms bridged
• Fuse rating : 40A x 1
• Length : 7-13/16"
• Height : 1-5/8"
• Width : 2-9/16"
• Frequency Response : 10 - 20kHz
• Signal-to-Noise Ratio : 95 dB
• Input Sensitivity :
• Low Level : 125mV–5V
• High Level : 250mV–10V
• Electronic Crossover : Selectable HI, LO or OFF; 80Hz, 120Hz HI or 80Hz LO; 24dB/octave slope
• Weather proof
• RCA & High-Level Inputs Connections
• Specifically designed for motorized vehicles
• No-rust, stainless-steel mounting hardware and a single Molex plug
• Preamp and speaker-level inputs as well as two auto turn-on modes (DC offset or 12-volt trigger)
• 8-gauge power and ground leads recommended (Not Include in This Amplifier)