- (2) Pairs of Rockville RV5.3A 5.25" 3-Way Car Speakers 600 Watts/100 Watts RMS CEA Rated
- (1) Rockville RockGhost Active 8" Car Subwoofer For 15"/16"/17" Full Size Spare Tire
- (1) Rockville RWK42 4 Gauge 4 Chan Car Amp Wiring Installation Wire Kit (2) RCA's
Video of RV5.3A:
Description:
Rockville car audio speakers utilize the latest in speaker technology for superior sound quality. We use top quality polypropylene cones which are known for their high damping qualities. This means they can have a controlled break-up, which results in a smoother high frequency roll-off. Our Flexmotion Butyl Rubber Surrounds give the speakers a smooth response with minimal distortion. For smooth and extended high frequency sounds we used high temperature PEI dome tweeters with ferrite magnets. The RV-A series speakers are designed with superior SPL response and extremely high power handling making these perfect for use with the amp built into your receiver or with a high powered external amplifier. Due to their shallow mount design, these speakers fit in 97% of all vehicles.
CEA Rated
Rockville car audio speakers are CEA rated, what that means is that the Consumer Electronics Association recognizes these speakers to be accurately rated and meet their rigorous standards for wattage, SPL and frequency response. So while other manufacturers state “out-of-this-world” wattages on their products, you can rest assured that your Rockville speaker will work up to spec. and exceed your expectations.
What’ so special about Rockville Speakers “in engineering terms”?
The acoustic center of a driver is the point in the driver from which the sound appears to originate. What is crucial in a good multi-element design is the difference between the centers of the drivers. This is called relative acoustic offset. A good speaker design features phase accuracy in and around the crossover point, because the interaction of the drivers is most affected by the SPL magnitude and phase in this area. The Rockville designs allow for wide dispersion of the sound for complete musical immersion.
Audio power is the electrical power transferred from an audio amplifier to a loudspeaker, measured in watts. The electrical power delivered to the loudspeaker and its sensitivity determines the sound power level generated with the balance being converted to heat. Amplifiers are limited in the electrical energy they can amplify; loudspeakers are limited in the electrical energy they can convert to sound energy without distorting the audio signal or destroying them selves. These power ratings are important to consumers finding compatible products and comparing competitors. Because Rockville products are CEA rated, you can easily and accurately match any Rockville speaker to a CEA rated amplifier and be guaranteed of their performance match.
Features:
- Pair Rockville RV5.3A 5.25" 3-way car speakers
- Peak Power Rating: 600 Watts per Pair / 300 Watts Each
- CEA Compliant RMS Rating: 100 Watts per Pair / 50 Watts Each
- Polypropylene woofer gives amazing bass and mids
- Flex Motion Butyl Rubber Surround
- 1.2” PEI dome tweeter with ferrite magnet give amazing highs
- 0.6” super tweeter
- Steel high quality basket
- Rubber magnet boot cover
- Frequency response: 55-20,000 Hz
- Sensitivity: 90 dB @ 1w/1m
- Impedance: 4 Ohm
- Grilles included
- Aluminum voice coils
- 100% oxygen free copper voice coil windings
- Cotton spider material
- Copper terminals
- Cutout diameter: 4.52”
- Magnet: 8 Oz Y25 magnet
- Magnet dimensions: 80mm x 12mm
- Fs: 117.456 hz
- Re: 3.6 OHM
- Qes: 2.561
- Qts: 1.681
- Qms: 4.888
- Fits 5.25” and 5” openings
- Top mounting depth: 1.89” 95% of installs use the top mounting depth)
- Bottom mounting depth: 2.1” (This measures the speaker from top to bottom)
About Rockville Quality Control Procedures:
The Rockville brand stands for Quality, Innovation and Value. All Rockville products go through the most rigorous quality control standards in the industry. Products go through months of extensive testing before they reach your hands. All user functions are tested and all internal components are tested for quality. Rockville makes products that are virtually un-breakable! Rockville is one of the only brands in its class to test every concept model for weeks or months before starting production. Once production begins, Rockville sends product engineers to their factory to quality control every line of production. During production every product is tested and on top of that Rockville goes the extra mile and has their high level product engineers do an additional quality control. They test a certain percentage of all products from the production line a second time to ensure that the quality meets their vigorous standards, and to make sure that there is never a batch of products with even a slight problem. All Rockville products are backed with a hassle free warranty, though it is unlikely that you will need to use it.
Video of RockGhost:
- **** Please check your cars spare tire wheel size to ensure fitment ****
- Rockville RockGhost Powered Car Subwoofer (Amplifier built in)
- Sub Fits Inside Spare Tire Seamlessly (Goes on top of spare tire so you can leave your spare tire in place)
- Hidden In Spare Tire - Takes up No Trunk Space
- Protected against theft because it is completely hidden in the spare tire
- 800 Watts peak output
- 200 Watts RMS output
- Voice Coil: Single
- For Full Size Spare Tire Wheel Sizes of 15"/16"/17"
- Extremely loud (loud enough to vibrate your mirrors)
- Super clean sound that is musical and will not fatigue your ears
- When this is mounted in your spare tire, the sound transmits cleanly and evenly throughout the vehicle without any vibrations or unwanted noises. It actually sounded better and cleaner than an ordinary sub in the trunk
- Tunnel air port design
- PWM MOSFET power supply amplifier built in
- Low level RCA inputs
- 8” high excursion Subwoofer
- Reverse mounting design
- Plug and play installation with wire harness containing power, ground, high level input, remote turn on, and RCA input
- Back plate mounts and screws right on top of spare tire
- Can also be mounted in trunk or under seat but we recommend mounting it in your spare tire
- Flexible rubber surrounds
- Wired 20 foot dash remote with adjustable gain, bass boost, low pass crossover filter, and phase control
- Deep and clear bass frequency
- Auto turn on and turn off
- Adjustable Input Sensitivity
- Soft Delayed Remote Turn-On
- Thermal Protection Circuit, Short Protection Circuit and Overload Protection Circuit
- Phase Switch: 0° or 180°
- Low Pass Filter: 50Hz - 150Hz
- Frequency response: 20 Hz – 250 Hz
- Bass Boost: 0 - 12dB @ 45Hz
- 20 Hz Subsonic Filter
- Cast aluminum casing
- Requires 10 gauge power wire
- Dimensions: 14.17” diameter x 5.7” height
- Includes all wiring needed for installation
Video of RWK42:
Video for Unboxing RWK42:
Description:
The Rockville RWK42 4 AWG (American Wire Gauge) amp kit has the following diferences over other amp kits on the market at this price point.
1. Our RCA cables are 100 % copper. These are top of the line RCA cables
2. Better Resistance: The only thing that really matters with wires is the resistance rating. This is a measurement of conductivity and how much signal is loss per foot of wire. Since Rockville wires are made with around 3 times as much copper as any other wire at this price point, these wires had a much better resistance rating which means they will transfer more power to your amps than the other brands.
3. We do not cheat you on the thickness of the wire. These are standard American wire gauge thickness. This is another reason our conductivity is better than anything else at this price point. Other brands in the market place write 4 gauge, but cheat you on the thickness. We are honest about the thickness.
4. The Rockville amplifier installation kits feature a new soft abrasion proof insulating jacket. This rugged PVC outer jacket allows for 100% improved flexibility over standard power cables making them extremely easy to route through your vehicles interior, and it maintains exceptional resistance to grease and oil. The PVC outer jacket can with-stand an extreme temperature range of -40 to 220 degrees F.
The RCA signal transfer cables included in this kit feature blue and silver twisted pair technology in a clear outer jacket insulation skin. Not only do the blue and silver wires look cool but they also provide superior signal transfer with maximum noise suppression. They are 100% copper to provide absolute lossless perfect signal transfer to your receiver. This technology reduces interference, so your audio signal flows clean and pure at all power levels.
This kit also includes a massive 80 Amp AGU Gold Plated Fuse, so you can be sure it will handle the all the DC power that your amp will need without even the slightest loss of current. The included 7 split loom tube provides protection for your power cable from the typically harsh environment found under the hood of your car.
Audiosavings product experts have tested this amp kit against many leading amp kits on the market and were were impressed not only by the great looks but by the quality of these Rockville installation kits as well. These kits had a lower resistance rating than the other brands we compared and tested them against. What this means is that Rockville manufactures their kits with more copper than other kits at this price point, ultimately providing your amplifiers with better and cleaner DC power, so they work cooler and more efficiently. You will hear the difference a Rockville installation kit will make!
One other last thing worth noting about our kit compared to others. Our kit cosmetically looks the best. It has blue power wire, clear ground wire, and twisted pair RCAs with matching colors. This model includes (2) sets of RCA cables.
Features:
- Rockville RWK42 4 Gauge 4 Channel Car Amplifier Wiring Installation Kit
- (2) 17 High Grade Twisted Pair of 100% Copper RCA Cable
- 17 4 Gauge Translucent Blue SuperFlex Power Cables
- 17 18 Gauge Blue Remote Cable
- 17 16 Gauge Clear Speaker Wire
- 3 4 Gauge Clear SuperFlex Ground Wire
- Gold Plated AGU Heat Resistant Fuse Holder
- 80 Amp AGU Gold Plated Fuse
- 7 Split Tube Loom
- Accessories Included: Wire Ties, Ring Terminals, Butt Connectors, Spades, and Grommets
- Soft abrasion proof insulating jacket allows for 100% improved flexibility
- PVC outer jacket can with-stand an extreme temperature range of -40 to 220 degrees F
The Rockville Difference:
Whenever you see the Rockville shield on a product you know that it has the stamp of approval. While other companies simply import products from China, Rockville manufactures the products in China to lower your cost but do so under American style supervision and quality standards to get you that USA quality that you want!
About Rockville Quality Control Procedures:
The Rockville brand stands for Quality, Innovation and Value. All Rockville products go through the most rigorous quality control standards in the industry. Products go through months of extensive testing before they reach your hands. All user functions are tested and all internal components are tested for quality. Rockville makes products that are virtually un-breakable! Rockville is one of the only brands in its class to test every concept model for weeks or months before starting production. Once production begins, Rockville sends product engineers to their factory to quality control every line of production. During production every product is tested and on top of that Rockville goes the extra mile and has their high level product engineers do an additional quality control. They test a certain percentage of all products from the production line a second time to ensure that the quality meets their vigorous standards, and to make sure that there is never a batch of products with even a slight problem. All Rockville products are backed with a hassle free warranty, though it is unlikely that you will need to use it.
Great features and great quality make Rockville a great choice.
- UPC:
- 613816416547
