Package Includes:

• (2) Rockford Fosgate Punch P3D4-10 10" 2000 Watt Dual 4 Ohm Car Subwoofers
• (1) Polk Audio PAD1000.1 Mono 1200 Watt RMS 1-Ohm Car Audio Amplifier Amp
• (1) Rockville RWK4CU 4 AWG Gauge 100% Copper Complete Amp Installation Wire Kit OFC

---

Features of P3D4-10:

• Rockford Fosgate Punch P3D4-10 10" 1000 Watt
• Size: 10 inches
• Peak Power: 1000 Watts
• RMS Power: 500 Watts
• Nominal Impedance: Dual 4-Ohm
• Anodized aluminum cone and dustcap
• Custom 10-AWG nickel plated push terminals
• Diamond cut cast aluminum trim ring
• Dual linear spider with embedded 16 AWG tinsel leads
• Extended pole piece and bumped vented backplate
• High-temp voice coil with spun-laced Nomex® re-inforcement collar
• Protective PVC textured magnet cover
• StampCast basket with integrated spider venting
• Cutout Diameter: 9.13 inches / (232 mm)
• Mounting Depth: 6.18 inches / (156.8 mm)
• Voice Coil Diameter: 2.5" / (65.5 mm)
• Magnet Weight: 81 oz / 2.30 kg
• Speaker Connector: Dual 10 AWG compression
• Shipping Weight: 17.3 Lbs / (7.8 kg)
• Fs (Hz): 28
• Re (Ohms): 6.40
• Le (mH): 7.0
• Qms: 5.00
• Qes: 0.63
• Qts: 0.56
• Vas (Liters): 27.0
• Sd (cm2): 360
• SPL (dB @ 1w/1m): 82
• Xmax (mm): 15.9
• Sealed - Enclosure
• Vb: 0.59 cu.ft
• F3: 41.1 Hz
• Qtc: 0.87
• Height: 12 inches
• Width: 14 inches
• Depth: 9.25 inches
• Speaker Cutout: 9.13 inches
• Speaker Depth: 6.18 inches
• Vd: 0.127 cu.ft
• Vented - Enclosure
• Vb: 1.40 cu.ft
• Fb: 40 Hz
• F3: 31.6 Hz
• Height: 12 inches
• Width: 20 inches
• Depth: 14 inches
• Np: 1 port
• Dp: 4 inches diameter
• Lp: 14 inches long
• Speaker Cutout: 9.13 inches
• Speaker Depth: 6.18 inches
• Vd: 0.127 cu.ft
• Vp: 0.102 cu.ft

---

Features of PAD1000.1:

• Polk Audio PAD1000.1 Mono 1200 Watt RMS 1-Ohm Car Audio Amplifier Amp PA D1000.1
• Super-Efficient Class D Design—Runs much cooler than conventional amps.
• High-Speed MOSFET Switching—Power supply with outputs stable into 1 Ohm loads.
• Protection—Thermal, DC offset, reverse polarity and short circuit protection.
• Variable Low-Pass Filter: 40 Hz - 220 Hz.
• Variable Subsonic Filter: 20 Hz - 38 Hz.
• Bass Boost at 0 dB - 12 dB.
• Bass Boost at 44 Hz.
• Remote Subwoofer Level Control.
• Nickel-Plated Wire Terminals & RCA connectors—Ensure maximum signal transfer.
• Level Control—Adjusts the gain of the channel to match the output voltage from your head unit.
• Line Level Outputs—Provides a full range signal for easy connection to additional amplifiers.
• Stainless Steel Hardware—Used throughout won’t corrode in humid environments.
  

Specifications:

• Type: Class D MOSFET
  
• Channels: monoblock
  
• RMS Continuous Power @ 4 Ohms: 500 W x 1
  
• RMS Continuous Power @ 2 Ohms: 800 W x 1
  
• RMS Continuous Power @ 1 Ohm: 1200 W
  
• Distortion at Rated Power: <0.1%
  
• Remote Gain Control Included
  
• Minimum Impedance Not Bridged: 1 Ohm
  
• Signal-to-noise Ratio: 105 dB
  
• Frequency Response: 20 Hz - 200 Hz
  
• Damping Factor: >150
  
• Crossover Filter Slope (dB/octave): 12 dB/octave
  
• Sub Sonic Filter Frequency Range: 20 Hz - 38 Hz
  
• Low Pass Filter Frequency Range: 40 Hz - 220 Hz
  
• Bass Boost Frequency: 44 Hz
  
• Bass Boost (dB) Variable (0 dB - 12 dB)
  
• Line Level Inputs
  
• Line Level Outputs
  
• LED Power Indicator
  
• LED Protection Indicator
  
• Input Sensitivity: 200 mV - 6 V
  
• Supply Voltage: 10 V - 16 V
  
• Fusing & Power/Type: (3) 40 Amp ATC
  
• Power Connections: 4 AWG
  
• Ground Connections: 4 AWG
  
• Speaker Connections: 12 AWG
  
• Height: 1 13/16" (46 mm)
  
• Depth: 6 3/4" (171.5 mm)
  
• Width: 12 15/16" (328.6 mm)
  
• Width w/ Terminal Adaptor: 13 11/16" (347.7 mm)
  
• Weight: 6 1/2 lbs (2.95 kg)

---

Video of RWK4CU:

Authorized Rockville Dealer!

We challenge anyone to put this wire to a resistance test against any other wire on the market with the same gauge. If our cable does not meet or exceed any other cable, even if it costs 3 times more, we will be happy to call tag the item and refund you in full. Why are we so confident ? This cable is 100% copper. You cant have a cable with more than 100 % copper. So the only way a cable would out-perform this one is if it were being advertised as a 4 AWG but they are giving you more wire than advertised. No brands selling 100 % copper cables actually do this.

We guarantee that this kit will compete with the most expensive amp kits on the market from Kicker, JL Audio, or any other top brands.

Maximum Power!
Looking for a wire kit that has 100% true specifications! A wire kit that uses 100% copper 4-gauge cable! Then look no further than the Rockville True-Spec RWK4-CU 4 Gauge Amplifier Wiring Installation Kit. This package includes everything you'll need to get your amplifier system powered-up correctly and at peak efficiency. All items included in this kit are top of the line.

The power and ground cables aptly named “Mega Power Cable” is a no compromise power cable. Rockville’s engineering team over-built and designed the cables using thousands of strands of only true 100% oxygen-free, silver-tinned copper strands. The use of a proprietary special twisting process reduces “surface skin impedance loss” so that Mega Power cables have zero signal and power loss, delivering full power from your battery system to your amplifier even at lengths of 20 feet! The increased current flow and higher amperage carrying capacity will increase your amplifiers efficiency and keep your amplifier running cooler. The SuperFlex outer insulating jacket jacket makes installation and cable routing simple and easy. The 100% copper stranded wire is extremely tolerant of the hostile conditions found under the hood in vehicles and compensates for vibration, heat expansion and flexibility. This flexible and well-shielded wire is crucial for getting through all of the nooks and passageways within the confines of a vehicle interior.

Some manufactures use all aluminum or mix a little copper with aluminum to give their cables the appearance of a “heavy-duty” cable. But not Rockville, our True-Spec 100% oxygen free, silver tinned copper eliminates corrosion, increases current transfer x 10, and won’t discolor over time.

The superior quality and materials of the Rockville 100% True-Spec amplifier installation kit is realized in the included accessories and cable workmanship. Included is a precision CNC cut full size ANL fuse housing, machined from solid brass and then 14K gold plated for superior signal transfer and complete with a matching gold plated 120-amp ANL fuse. The power cable is wrapped in 6 feet of durable nylon braided tubing to protect it from heat and chafing in the engine compartment. All installation accessories such as the ring terminals and spade connectors are nickel plated for superior signal transfer and durability.

CRYSTAL SQ AUDIO PLANAR SPEAKER CABLE
The speaker cable included in the Rockville True-Spec is also manufactured from 100% copper and woven in to a flat planner design and coated in our Super-Flex insulation so that it fits under and around your vehicles trim and carpet smoothly and without bulking up. With crystal clear sound quality these speaker cables deliver true audio fidelity from your car audio amplifier to your speakers. The 14-gauge speaker cable included in the 4-gauge kit can handle over 2000 watts of power without heating up or degrading signal quality.

CRYSTAL SQ RCA AUDIO INTERCONNECT CABLE
Designed and engineered to be the best sounding, best performing and best looking RCA cables available today. Each channel in the RCA cable is triple shielded first with dielectric internal insulators and then with a 98% coverage woven shield. All cables are manufactured of 100% oxygen free copper and feature twisted pair technology for superior noise rejection and pure sonic signal flow. The RCA plugs are shielded metal and feature a spiral cut outer ground ring with center split pin for precise and tight audio connections. The result of all this technology is noise free-noise rejection signal transfer for optimum sound quality. You will hear the difference these RCA signal transfer cables will make.

Amplifier Kit Key Features:

• Rockville RWK4CU 4 Gauge 2 Channel Complete Car Amplifier Installation Kit 100% Pure Copper RCA Cables
  
• 4 Gauge Power Amplifier Installation Kit
• Designed specifically for car audio systems over 1000 watts RMS to 2000 Watts
• Made from silver-tinned 100% virgin copper for a pure uninterrupted transfer of power and signal
• The solid brass gold plated Mini ANL Fuse Holder offers ideal protection for high powered systems
• Strand Count: 1862
• BC-5W2 Compliant

Kit includes:

• 17 ft. Frosted Blue 4 gauge power wire with seamless crimp ring terminal
• 3 ft. Frosted Gray 4 gauge ground wire
• 17 ft. Blue 18 gauge remote lead wire
• 25 ft. Frosted Clear/Blue 14 gauge flat speaker wire
• 17 ft. Triple shielded twisted pair RCA cables
• One Mini ANL Fuse Holder with 120 amp ANL fuse
• One 1/2“ black rubber firewall grommet
• One 4 gauge spade terminal
• Two black 12 gauge nickel-plated spade lugs
• Three blue 12 gauge nickel-plated spade lugs
• One black 4 gauge ring terminal
• Ten 6” black zip ties