Package Includes:

• (2) MB Quart NK2-116W 6.5" 120 Watt 2-Way Marine Boat Speakers in White
• (1) Rockville KRYPTON S6 Marine/Boat 2600 Watt 6 Channel Amplifier + PA Microphone
• (1) Rockville RMWK4 4 AWG Gauge Waterproof Marine Amplifier/Amp Install Wire Kit
• (2) Rockville MRCA25 25 Foot Twisted Pair Marine RCA Cable 100% Copper, Split Pin

---

Description:

An award winning, marine certified premium 6.5 inch coaxial speaker for boat, RV and off-road vehicle audio installations. These speakers feature water resistant midrange cones, titanium tweeters and rust resistant connectors. Sold in pairs with grills in white.

Features:

• Marine Grade Protection / IPX Rating
  LIFE SHIELD: Protected for water and dirt. UV protected against sun fade. Longer life against harsh conditions. Protected against sun fade with UVA paint coating. Conformal coated crossover components protect against fresh and salt water spray as well as dust and sand. IPX67: Tested to the highest Marine and Motorsports standards for resisting the elements.
• Tweeters
  .75 Inch Pure Titanium Dome Tweeter: Very smooth musical response, high output with minimal required amplifier power.
• Cone Material
  6.5 Inch Composite Poly Midrange: Water resistant composite polypropylene cone with temperature stable Butyl rubber surround mounted on a lightweight composite frame.
• Surround / Cone Coupling
  Natural Butyl Rubber: Remains musical in all weather. Does not stiffen in cold.
• Voice Coil / Former Assembly
  High Temperature Voice Coil and Former: Voice coil is high temperature copper, wound on a Kapton former which allows the voice coil to handle more power while remaining light in weight.
• Spider
  Water resistant spider: oven fiber composite spider to stabilize the cone and voice coil in all musical situations.
• Cooling System
  Front and Rear Venting: Air passes through the spider and back plate to exchange air over the voice coil.
• Crossover
  Marine Certified Crossover: Conformal Coated, Butterworth 12dB per octave crossover with PTC (Positive Thermal Coefficient) tweeter protection. Smooth transition from high to lower frequencies remain musicial and not harsh or distorted.
• Frame
  Composite ABS and glass fiber frame: Composites add strenth to the frame without adding distortions or harmonics that can affect the tonal quality of the speaker.
• Motor
  High Energy Y30 Motor assembly: High energy strontium ferrite magnet for higher output with minimal amplifier power.
• Grills
  Composite: UV treated against sun fade and waterproof.

Specifications:

• Weight: 5.3 lbs
• Type: Speaker
• Brand: MB Quart
• Series: Nautic
• Category: Marine, Powersports
• Condition: New
• Color: White
• Warranty: 1 Year
• IPX Rating: IPX67
• CEA Standards: CEA426B
• Speaker RMS Power Handling (watts): 60
• Speaker Peak Power Handling (watts): 120
• Speaker Impedance (ohms): 35Hz-21kHz (+/- 10dB)
• Speaker Sensitivity: 87.7 dB
• Speaker Height (in): 1.13
• Speaker Mounting Diameter / Cut Out (in): 5.59
• Speaker Outside Diameter (in): 6.8
• Speaker Mounting Depth / Chassis Depth (in): 3.7
• Speaker Size (in): 6.5
• Proposition 65 Notice: WARNING: This product can expose you to chemicals including LEAD, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

---

How To Install a Marine Amplifier onto Your Boat:

All About Your KRYPTON S6:

What's In The Box:

• Amplifier
• Bass Remote
• PA Microphone
• Birth Sheet with Dyno-tested power
• Mounting Screw Kit
• Owner's Manual
• Warranty
• Instructions including installation video

Description:

The all new Krypton marine series of amplifiers gives you the best of both worlds! Small footprint and big power! These amps also have great features like built in volt meter. This amp also includes a PA microphone for making announcements to your friends. We also include a remote knob allowing you to adjust the output from the remote.

The KRYPTON S6 is a class A/B 6-Channel high power amplifier with 2,600 watts peak output and 660 watts RMS (Certified dyno-tested RMS power). The RMS power is tested on a dyno using the certified run. It puts out 110 watts x 6 channels at less than 1% THD at 14.4 volts. We give you the dyno-tested power as well as a peak power rating to make sure you can compare our amp to other brands regardless how they like to rate their amps.

This amp has enough juice to power either (12) speakers, (6) speakers, (3) subwoofers or a combination of subwoofers and speakers. It is also perfect for mids and tweeters.

This amp has a very cool fully adjustable 12dB/Octave crossover. What is cool about it is that the crossover supports low pass, full, and high pass. This makes our amp ideal for subwoofers (sealed and vented), full range speakers, midrange speakers, and even tweeters. In high pass mode we allow you to filter out the lower frequencies (cut-off frequency adjustable between 15Hz - 4K Hz). In low pass mode we allow you to filter out the upper frequencies (cut-off frequency adjustable between 40Hz - 4K Hz). In full mode you will not be filtering any frequencies. Our advanced crossover technology will allow you to really fine tune each speaker to get the sound you desire.

The other cool thing is that this amp has 4 of these crossovers. Every 2 channels has its own set of advanced filters. So if you wanted you can use 2 channels for subwoofer(s) and 2 channels for full range speakers and 2 channels for mid or tweeters.

This amp utilizes high grade marine components including a conformal coated PCB board with a waterproof glue that is painted on to protect the circuitry. The heat sink casing, including the bottom plate, is made of stainless steel which is rustproof. The end panels, the internal mounting screws and hardware of the amp are made of stainless steel and are rustproof as well. Even after many years of use the amp will be rust free and operate like new!

Features:

• Rockville KRYPTON S6 2600 Watt Peak/660 Watt RMS 6 Channel Class AB Marine Stereo Amplifier
• Dyno certified RMS Power: (less than 1 % distortion) (Use these ratings when comparing with other premium brands such as Kicker, Rockford Fosgate, etc.)
• 2 Ohm: 110 Watts x 6 Channel <1% THD+N @ 14.4 Volts
• 4 Ohm: 75 Watts x 6 Channel <1% THD+N @ 14.4 Volts
• 4 Ohm Bridged: 220 Watts x 3 Channel <1% THD+N @ 14.4 Volts
• Peak Power: (Use these ratings when comparing with great budget brands such as Boss, Power Acoustik, Crunch, etc.)
• 2 Ohm: 440 Watts x 6 Channel
• 4 Ohm: 300 Watts x 6 Channel
• 4 Ohm Bridged: 880 Watts x 3 Channel
• Digital Voltage Display on Amp
• Microphone input and PA microphone included
• Adjustable Low Pass Filter: 40Hz - 4KHz
• Adjustable High Pass Filter: 15Hz - 4KHz
• Adjustable Band Pass Filter: 15Hz - 4KHz
• Painted Conformal Coating PCB Board (Uses 2577 Waterproof Glue)
• Rustproof Aluminum heat sink with black hairline finish
• Stainless steel end panels are rustproof
• All screws and mounting hardware are stainless steel and rustproof
• Bottom panel is aluminum and rustproof
• 4 Gauge power and ground terminals
• 10 Guage speaker wire terminals
• All channels on the amp have crossovers so they can each be used for subs or full range speakers or tweeters or midrange speakers
• All channels on the amplifier are bridgeable
• High-Speed MOSFET Power Supply
• Under Voltage Protection at 10V
• Over Voltage Protection at 16V
• Tertiary Supplies Circuitry
• Studio-Grade Bipolar Output Stage Transistors
• Fully Adjustable 12dB / Octave Crossover with Differential Circuitry
• Full IC-Controlled Protection Circuitry
• Fully Adjustable 12dB Bass Equalizer
• Adjustable Input Level Control
• Mute and Delay Soft Start System
• 2CH/4CH/6CH Input Mode Switch
• 8 Volt Preamp Circuitry
• Status Mode LED Indicator
• Minimum THD at Rated Power: < 0.05%
• S / N Ratio: >90dB
• Frequency Response: 10Hz - 50KHz
• Damping Factor: >85 @ 100Hz
• 30 Amp x 3 ATC Fuse
• Dimensions: (W x H x L) 8.66" x 2.2" x 18.3"

---

Video of RMWK:

Features:

• Rockville RMWK4 4 AWG Gauge Waterproof Marine/Boat Amplifier Wire Installation Kit
• 20' Translucent, Twisted Pair, High Quality, Tinned-OFC Flexible PVC RCA Cable
• 18' 4 Gauge High Current, Low Impedance, Clear Flexible Power Cable with 3' Black Poly Woven Mesh to better resist chemicals in the battery compartment
• 18' 4 Gauge High Current, Low Impedance, Light Blue, Flexible Ground Cable
• 25' 16 Gauge 100% Tinned-CCA, White, Non-Transparent Resin PVC, Flat Speaker Cable
• 25' Blue Remote Wire
• (1) Silver Mini-ANL Fuse Holder - Clear Shell and Clear Blue Bottom Bracket with Blue Waterproof Ring
• (1) 120A Mini-ANL Fuse
• (1) 80A Mini-ANL Fuse
• (2) Ring Terminals
• (2) Spade Terminals
• (5) Speaker Cable Terminals
• (1) Washer
• (10) White Cable Ties

---

Description:

Rockville marine audio interconnect cables are specifically engineered to withstand the challenges of both salt water and fresh water marine installations. The utilization of tinned OFC copper conductors with polyethylene dielectrics in a twisted-pair arrangement optimizes noise rejection. The small-diameter white PVC jacket is ultra-flexible enabling our cables to be easily routed around bends and through tight spaces. Our exclusive molded connector features a water proof inner cap that is heat shrunk in place over all solder connections thus guaranteeing a completely water proof and corrosion resistant connection. Our locking plug design with split pin technology further insures tight connections that will not vibrate free even during the most extreme boating maneuvers.

Features:

• Rockville MRCA25 RCA Interconnect Cable
• 25' Ultra-Flexible PVC Shield
• Twisted Pair
• Premium Audiophile Marine RCA Interconnect Cable
• High Performance Water Proof RCA Plugs
• Tinned Copper Strands for Sonic Purity
• Outstanding Noise Rejection, Accuracy, and Frequency Response