Package Includes:

• (2) Pairs of Rockville MS40B Black 4" 200 Watt Marine Boat Speakers Compact and Powerful
• (1) Hifonics TPS-A350.4 350w 4-Channel Marine Amplifier For Polaris RZR/ATV/UTV/Cart
• (1) Hifonics TPS-BT1 Bluetooth Marine Pre-Amp Controller 4 Polaris RZR/ATV/UTV/Cart

---

Video of MS40:

 What's In the Box:

• 2 Speakers
• Installation Hardware: (8 Stainless Steel Screws + 8 Stainless Steel Speed Clips)
• Mounting Template
• Owner's Manual
• Warranty Card

Features of MS40B:

• Pair Rockville MS40B 4" 200 Watt Waterproof Marine Boat Speakers
• Peak Power: 200 Watts per pair / 100 Watts each
• RMS Power: 50 Watts per pair / 25 Watts each
• Color: Black
• Injection Molded Polypropylene Cone
• Aluminum voice coil with ASV winding
• Cloth surrounds
• Impedance: 4 Ohm
• Frequency Response: 122Hz – 20 Khz
• Sensitivity: 85dB @1w/1m
• High quality magnet: 3.5 Oz Y30 Ferrite magnet
• 1” inch ASV voice coil
• IP56 waterproof rating
• Fully Marinized Against Salt & Fresh Water Conditions
• Completely Waterproof and rustproof at level IP56
• Anti-UV molded ABS plastic basket & grill
• Pre-installed mounting screws included
• Perfect for marine, outdoor, and car use
• 1” inch Tweeter: (Mylar Diaphragm with NdFeB magnet)
• Injection Molded Polypropylene Dust Cap
• SPL: 85dB ± 2dB (at 1M / 1W)
• Resonant Frequency (F0) 122Hz + or – 20% at 1V
• 3MM plate and 3 MM T-yoke
• Total Diameter: 5.12”
• Cutout Diameter in Inches for Mounting: 3.66”
• Total Height: 2.36”
• Mounting Depth in inches:1.57’’
• Shipping weight: 1.76 Lbs
• Shipping Dimensions:6” x 6” x 5.7”

T/S Parameters:

• Magnet details: F60*F24*8 Y30
• Fs:154.7 Hz
• Re:3.2 ohms
• Qes:2.57
• Qts:1.611
• Qms:4.315
• Vas:0.847L
• Cms:210.222UM/N
• Bl:2.468T
• MMS:5.029g
• XMAX:1.5 mm
• SD:54 cm2

---

Description of TPS-A350.4:

Hifonics THOR compact Four Channel, 350 watt Powersports amplifier with on-board equalization and simple installation with quick release connectors.

Features:

• Hifonics TPS-A350.4 350w 4-Channel Marine Amplifier For Polaris RZR/ATV/UTV/Cart
• Marine Grade Protection: YES - Amplifiers are ABYC & ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.
  
• Pre-Amp Circuitry: Low Noise Pre-Amplifier Stage - Special preamplifier reduces incoming noise from source units dramatically improving sound quality
  
• Inputs: 2 Pair, RCA Nickel-Plated - High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant
  
• Operation Mode: Four channel operation - Flexible installation allows this amplifier to run in four channel or bridged mono mode.
  
• Crossover / Signal Shaping: Switched FULL / LPF / HPF - Complete control of amplifier signal, essential when using two or more amplifiers
  
• Class / Topology: Full Range Class D - Highly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.
  
• Output Devices Technology: PWM MOSFET Power Supply - Stable power through the PC board with minimal heat generation
  
• Heat Sink: Aluminum - Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration
  
• Power Supply: Simpatico Coil Design - The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices
  
• Output Connections: Quick Dissconect Wires, RCA Connections - Quickly remove amplifer when you are putting machine up for the winter of as a security precaution
  
• Connections Type: Gold-plated connections - Gold-plated power, ground, speaker and RCA corrosion resistant connections
  
• Diagnostics: Three-stage protection circuits - Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel
  
• Marinized / Waterproof: YES - Water resistant for durability in any environment
  

Specifications:

• Class: Full Range Class D
  
• Variable Voltage: 0.2V~9V
  
• Signal to Noise Ratio: >90dB
  
• Frequency Response: 20Hz-20kHz
  
• Crossover Frequency Range CH1 & CH2: Switched HP/ Full
  
• Crossover Frequency Range CH3 & CH4: Switched HP/ Full
  
• Bass Boost: 0-12dB@45Hz
• Power @ 2-Ohms: 4 x 80W
  
• Power @ 4-Ohms: 4 x 40W
  
• Total Channels: 4
  
• Audio Inputs: RCA
  
• Power Terminal 12v/GND: Molex 10 ga
  
• Speaker Terminal Wire Gauge: Molex Plug Connector
  
• Fusing: 1 x 30 Amps
  
• Certifications: Marine & Powersports
  
• Dimensions: 3.70 X 5.51 X 1.77 inches (9.4 X 14.0 X 4.5 cm)
  
• Weight: 2.16 lbs (0.98 kg)

---

Description of TPS-BT1:

For installations where a full size radio/source until will not fit, Hifonics has designed the ridiculously small TPS-BT1 Bluetooth, pre-amp controller. That model comes from THOR Power Sports Bluetooth 1. It might be your favorite controller you have ever used. The amount of control and connectivity you will have at your fingertips is shocking.

All the music, from your Bluetooth enabled device, directly into your system via this small controller. The TPS-BT1 is fully IPX67 protected against the elements so it is perfect for installation right in the dash of your Side-X-Side or off road application.  

For custom car builders, looking to keep an original clean look, This Bluetooth controller is a great option to changing out the original dash radio in a classic.    

Features:

• Hifonics TPS-BT1 Bluetooth Marine Pre-Amp Controller 4 Polaris RZR/ATV/UTV/Cart 
• Pre-amp controller
  
• Volume and track selection are controlled by the multi-functional joystick
  
• 2 volts output
  
• Waterproof Bluetooth controller designed to fit into a small hole
  
• iPhone, Android & Bluetooth Device Ready