- (2) KICKER 48CWRT104 CompRT 800w Shallow 10" Subwoofer DVC 4-ohm Car Sub COMPRT10
- (1) Rockville KRYPTON-M3 4000w Peak/1000w Dyno-Certified RMS Mono 1 Ohm Car Amplifier Amp+Remote
- (1) Rockville RWK41 4 Gauge Complete Car Amp Wiring Installation Wire Kit with RCA's
WHAT MAKES IT SUPERIOR?
- New and Improved – True Subwoofer Performance from a Thin Driver
- Features Forced-Air Cooling™ - 20% Cooler for Increased Reliability
- Legendary KICKER Bass in a Thin Subwoofer
Specification:
- Woofers: 10, 25 in, cm
- Impedance: 4 Ohms
- Recommended Amp Power: 400 watts RMS
- Peak Power Handling: 800 watts
- Frequency Response: 25-500 Hz
- Sensitivity: 84.8 dB 1w/1m
- Mounting Depth: 3-7/16, 8.8 in, cm
- Xmax [Linear Excursion]: 10.5 mm
What's in the Box:
- Amplifier
- Bass Remote with clipping indicator
- Birth sheet with tested power
- Owner’s manual
- Mounting Screws
- Warranty
Description:
The Krypton series of amplifiers by Rockville are engineered to have the best reliability and features. Whether you are a car audio competitor or just like to enjoy loud music. We engineered and designed these amps from the ground up to give you great sound quality and great features. You will notice the cool battery voltage display meter which looks great but also serves as a tool for you to know if your battery voltage is dropping which would affect your systems performance. We designed the amps to be able to last for many years even if you are playing them at max volume before clipping for extended periods of time.
Our favorite feature we introduced of the Krypton series is the bass remote that has a clipping indicator. This allows you to set the amp to max output before clipping on any song. This will protect your subs while you maximize SPL. What is nice about this is that you can set the gain level to max before clipping on any given song in real time! If you use a DD-1 or another tool, you are setting the gain on one song but the next song might have more headroom or might clip depending on the levels it was recorded at (this is referred to as crest factor in the engineering world)
We guarantee that this series of amplifiers will not only meet their rated power but exceed their rated power on a certified dyno test.
Another feature we love about this is the bass equalizer. Most amps have this feature however not all bass EQ are created equal. Some bass EQ's will just clip your subs to death. Our bass EQ circuitry will boost the proper frequencies in a way that sounds good and is safe for your subs. In addition you can always use the clip indicator on the bass remote to make sure you are not sending a clipped signal to your subs. Our amplifier is meant to give you as much clean power to your subs as possible. Our voltage display allows you to make sure you are getting the proper voltage to your amp and our clip indicator on the remote will make sure you always send clean power to your subs. In addition we also guarantee the amplifier will be giving over the rated power so you can confidently match our amplifier with high-end subs and know what to expect!
What about sound quality and efficiency though ??
Well glad you asked. This amplifier is engineered so well that it has an extremely low signal to noise ratio which just means the sound will be super clean even at high volume levels. It also has a good efficiency rating so you don't have to draw too much power from your battery. One other thing that is important is that we engineered this to have a high common mode rejection rating (CMRR). This means that the amp has the capability to block out engine noise signals. By rejecting unwanted noises the end result is the cleanest sound quality.
Once again, Rockville has stepped up its game with the all new Krypton series. Their is no other amp like it on the market. In our opinion this is the best budget series of amps in the world. We actually enjoy this amp more then others that cost over 2 times the price.
Features:
- Rockville KRYPTON M3 4000 Watt Peak and 1000w RMS Class D 1 Ohm Stable Mono Amplifier With Voltage Display
- Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc)
- 1 Ohm: 1000 Watts x 1 Channel <1% THD+N (71% efficient)
- 2 Ohm: 700 Watts x 1 Channel <1% THD+N (79% efficient)
- 4 Ohm: 400 Watts x 1 Channel <1% THD+N (84.5% efficient)
- Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc)
- 1 Ohm:4000 Watts x 1 Channel
- 2 Ohm:2800 Watts x 1 Channel
- 4 Ohm:1600 Watts x 1 Channel
- Digital Voltage Display on Amp (Accurate within 0.15V)
- Power/Protect/Clip LED Indicators on the front panel
- Power/Protect/Clip LED Indicators on Remote control
- Clip indicator on the bass remote allows you to quickly set any song to right before clipping in real time
- High-Speed MOSFET Power Supply
- Optical Coupler Class “D” Technology
- Fully Adjustable 12dB / Octave Crossover with Differential Circuitry
- Low Pass Filter: 50Hz - 250Hz
- Subsonic Filter: 15Hz - 55Hz
- Phase Control Switch
- Full IC-Controlled Protection Circuitry
- Remote Dashboard Subwoofer Control
- Fully Adjustable 12dB Bass Equalizer
- Mute and Delay Soft Start System
- RCA Preamp Line Output
- 8 Volt Preamp Circuitry
- Status Mode LED Indicator
- Minimum THD at Rated Power: <0.1%
- S / N Ratio: >90dB
- Frequency Response: 15Hz - 250Hz
- Damping Factor: >150 @ 100Hz
- 2 x 60 Amp Maxi Fuse
- Passes the Signal Burst Test (Instant signal for full power “SPL Contest”)
- Rockville engineered with a super low signal to noise ratio to give you clean sound
- Improved Bass EQ filter works better then any other brand we tested against
- Dimensions: (W x H x L) 13.78" x 8.66" x 2.2"
Video of RWK41:
Unboxing Video for RWK41:
Description:
The Rockville RWK41 4 AWG (American Wire Gauge) amp kit has the following differences over other amp kits on the market at this price point.
1. Our RCA cables are 100 % copper. These are top of the line RCA cables
2. Better Resistance: The only thing that really matters with wires is the resistance rating. This is a measurement of conductivity and how much signal is loss per foot of wire. Since Rockville wires are made with around 3 times as much copper as any other wire at this price point, these wires had a much better resistance rating which means they will transfer more power to your amps than the other brands.
3. We do not cheat you on the thickness of the wire. These are standard American wire gauge thickness. This is another reason our conductivity is better than anything else at this price point. Other brands in the market place write 4 gauge, but cheat you on the thickness. We are honest about the thickness.
4. The Rockville amplifier installation kits feature a new soft abrasion proof insulating jacket. This rugged PVC outer jacket allows for 100% improved flexibility over standard power cables making them extremely easy to route through your vehicles interior, and it maintains exceptional resistance to grease and oil. The PVC outer jacket can with-stand an extreme temperature range of -40 to 220 degrees F.
The RCA signal transfer cables included in this kit feature blue and silver twisted pair technology in a clear outer jacket insulation skin. Not only do the blue and silver wires look cool but they also provide superior signal transfer with maximum noise suppression. They are 100% copper to provide absolute lossless perfect signal transfer to your receiver. This technology reduces interference, so your audio signal flows clean and pure at all power levels.
This kit also includes a massive 60 Amp AGU Gold Plated Fuse, so you can be sure it will handle the all the DC power that your amp will need without even the slightest loss of current. The included 7 split loom tube provides protection for your power cable from the typically harsh environment found under the hood of your car.
Audiosavings product experts have tested this amp kit against many leading amp kits on the market and were were impressed not only by the great looks but by the quality of these Rockville installation kits as well. These kits had a lower resistance rating than the other brands we compared and tested them against. What this means is that Rockville manufactures their kits with more copper than other kits at this price point, ultimately providing your amplifiers with better and cleaner DC power, so they work cooler and more efficiently. You will hear the difference a Rockville installation kit will make!
Features:
- 1 – 17’ High Grade Twisted Pair of 100% Copper RCA Cable
- 17’ – 4 Gauge Translucent Blue SuperFlex Power Cables
- 17’ – 18 Gauge Blue Remote Cable
- 17’ – 16 Gauge Clear Speaker Wire
- 3’ – 4 Gauge Clear SuperFlex Ground Wire
- Gold Plated AGU Heat Resistant Fuse Holder
- 60 Amp AGU Gold Plated Fuse
- 7’ Split Tube Loom
- Accessories Included: Wire Ties, Ring Terminals, Butt Connectors, Spades, and Grommets
- UPC:
- 613817031275
